windshield washer check valve

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

ron3033

New Member
Joined
Oct 14, 2012
Messages
3
Reaction score
0
1995 Chev Tahoe 4 door 4 wheel drive
The windshield washer check valve located under the floor near the gas filler neck gave out. Got the replacement (tried 2 of them) which is an ANCO # 48-21 and they do not function properly, and I have mounted it the correct way and the incorrect way. It seems it does not have enough ability to close the valve to keep it from flowing out, and but will open when pump is activated. All it does is allow the whole reservoir to dribble out the spray head on the rear washer arm.
GM can't get one.
If I leave the Tahoe in the drive it is empty in about an hour, so right now it is plugged off.

Any Suggestions as I have no rear wash because of a plastic part. photos attached I hope. Vacuum check valve work??
ron3033 :waytogo:
 

Attachments

  • HPIM1899.jpg
    HPIM1899.jpg
    66.9 KB · Views: 1
  • HPIM1900.jpg
    HPIM1900.jpg
    22.7 KB · Views: 1

ron3033

New Member
Joined
Oct 14, 2012
Messages
3
Reaction score
0
Lesterl I tried one, it did not work> Do you remember what worked for you?? The Anco 4821 is suggested replacement but DOES NOt WORK.

Thanks
ron3033
 

lesterl

Full Access Member
Joined
Oct 10, 2011
Messages
2,597
Reaction score
1
Location
MO
Been a long time (few years), sorry don't recall.....
 
Top