stuck in limp mode:(

[98vortec23]

Ok so I pop a code, replace the 1&2 3&4 shift solenoids, but I think my boss screwed up cause she had the code read. Before I did the work!please help. Tried the disconnect of the bat for 30 nothing. And help would be much appreciated.

 

[lesterl]

What exactly do you want? You need a scantool to reset a code (or most cheap code readers), or cycle the ignition on/off like 50 times.....

 

[98vortec23]

I would like some ideas on what could be the problem, the code was cleared before I replaced the two shift silonids, put new fluid and trans filter. Still wont come out of limp mode.

 

[lesterl]

By limp mode I am assuming that it is staying in 3rd gear only, so suspect either the connector to the transmission and also check the fuse that feeds the transmission as either of these will cause that scenario....