Mcgaughy's 3/5 Instructions????
- Thread starter allando
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
when i bought my rear 5" kit from them i also got the 2000+ instructions.... it must be the same way to instal it because it worked out fine for me...
EXCEPT!!!!! in the instructions it doesnt say to make sure you disconnect your sensor wires!! when i was lowering the rear axle to remove the factory coils i might have messed up the sensor wires at full droop..
NOW, my stabilitrac light, ABS light, and traction control light is on!!
it says on there instructions to make sure you read it carefully! I DID! and it said nothing about the sensor stuff.
i havent had a chance to check under there yet and see what could have gone wrong.. i just lowered it today so we'll see on my next day off.
EXCEPT!!!!! in the instructions it doesnt say to make sure you disconnect your sensor wires!! when i was lowering the rear axle to remove the factory coils i might have messed up the sensor wires at full droop..
NOW, my stabilitrac light, ABS light, and traction control light is on!!
it says on there instructions to make sure you read it carefully! I DID! and it said nothing about the sensor stuff.
i havent had a chance to check under there yet and see what could have gone wrong.. i just lowered it today so we'll see on my next day off.
You might have stratched the wires & caused an open in the circuit.... Hopefully you know someone @ the dealership so they can warranty it for you. Yeah, I didn't reposition the sway bar like the instructions said to do. I just didn't see how doing that would make any sense, so I did my own thing. No problems so far....:thumbsup:
OCTAHOE
New Member
Is there a fuse you can pull to stop the sensor from going off? Mine is always on since I did the 24s and it drives me nuts.
B
B
Are you talking about the ABS light? You might have to reprogram the electronic brake control module (EBCM) to compensate for the larger diameter wheel/tire.
VadersOwnZ71
Full Access Member
Noble, same thing happened to me when I dropped my ride. We put everything back together and and lo and behold all those warning lights you mentioned were on.
You will need to look under at the rear passendger side. I found a set of wires with a quick release plastic mechanism just hanging there obviously disconnected. It took some searching, but I eventually found the other end where it plugs in to. Like I said, mine was on the passenger side and I'm not sure if there is a similar one on the driver side, but look on the passenger side first. You should see the wires hanging around the suspension area. Sorry, I don't have a pic.
Anyways, once I reconnected the wires, the warning lights went out and I've had no problems since. Good luck.
TaHeezy4Sheezy
New Member
- Joined
- Sep 5, 2007
- Messages
- 41
- Reaction score
- 0
I just got the air bag helper kit for my 3/5... Has anybody put this on?
I'll be putting mine on sometime this week. I'll let you know how it goes.
TaHeezy4Sheezy
New Member
- Joined
- Sep 5, 2007
- Messages
- 41
- Reaction score
- 0
I think Ima try to install mine on compressors.. If thats possible... Let me know.. Im curious how well this works!
I think if you were to do that, you only would need one small compressor.
Grocery Getter
Full Access Member
Hello, I am going to install the 3/5 drop kit on my 04 Tahoe this weekend. I picked up the kit and it only has instructions for the front. I was wondering if you could hook me up with the instructions for the rear. Let me know.....
