2007 Yukon Grill
- Thread starter O Dogg
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Where are the clips? Perhaps they're in the same spot...
chadlewis
Full Access Member
there are 2 clips on both sides of the grill along with 4 clips on the bottom of the grill...i used a flathead screwdriver to press the clips down and once you get them all unclipped, it slides right out.
Hate to be a pain, but would there be anyway to show me where these are on a photo? Thanks!
Here you go, I don't have a Yukon but a Tahoe so I found a pic and circled some clips for you!
http://s285.photobucket.com/albums/ll55/nnaboyq156/?action=view¤t=Yuk.jpg
http://s285.photobucket.com/albums/ll55/nnaboyq156/?action=view¤t=Yuk.jpg
NN...thanks! Exactly what i was looking for. I see some slits in the areas you marked...pretty narrow, though. Perhaps a butter knife could slide in there?
chadlewis
Full Access Member
Here is a close up of the clip if you need it...press down on the middle of the clip and it should release
Here is a close up of the clip if you need it...press down on the middle of the clip and it should release
Okay...I am a moron, apparently. I can see the top two clips BUT I CANNOT GET THEM OUT!!!
Last edited:
chadlewis
Full Access Member
Really isn't that hard, once you figure out how to to the first clip the rest is as follows.
As for the process,
if you are facing the grill and working on the left side (2) of the grill, press the middle of the clip to the left and pull the side of the grill towards you, so the clip the clip doesn't slip back in
for the right side (2) of the grill, press the middle of the clip to the right and pull the side of the grill towards you, so the clip doesn't slip back in
and for the bottom clips (4) press the middle of the clip towards the bottom and pull the side of the grill towards you, so the clip the clip doesn't slip back in
*i used a tiny flathead screwdriver to do all the work
As for the process,
if you are facing the grill and working on the left side (2) of the grill, press the middle of the clip to the left and pull the side of the grill towards you, so the clip the clip doesn't slip back in
for the right side (2) of the grill, press the middle of the clip to the right and pull the side of the grill towards you, so the clip doesn't slip back in
and for the bottom clips (4) press the middle of the clip towards the bottom and pull the side of the grill towards you, so the clip the clip doesn't slip back in
*i used a tiny flathead screwdriver to do all the work
chad, thanks for the help...you were 100% correct...after the first clip, it was pretty much smooth sailing.
I will say this...the first clip finally came through after I took the "At this point, I don't care if I break it" perspective. I guess I was just being to careful earlier.
Thanks again for the help. The grill is now taped off and the emblem has been sanded and primed....paint and clear to follow later.
I'll post pics when finished.
I will say this...the first clip finally came through after I took the "At this point, I don't care if I break it" perspective. I guess I was just being to careful earlier.
Thanks again for the help. The grill is now taped off and the emblem has been sanded and primed....paint and clear to follow later.
I'll post pics when finished.
Similar threads
