Search results

I'll try to check that today but I don't have a jack. How far is the actautor supposed to extend? I think it might not be extending out enough. It looks weird when it opens... Like it should go further. I don't know if that rubber is supposed to completely straighten out or not. Because it...

So today put it in 4hi and noticed the driveshaft doesn't move anymore. But I have a question... Is the front axle actuator supposed to extend all the way. It seems like it's not opening enough or something. It opens about an inch or an inch and a half. Can't find a picture of it opened all the...

Unless you want to email me what you have and I'll tell you if I have the same. Or give me your email and I'll email it to you. Thanks

Can't post it from iPhone...guess I'll have to do it on laptop

Here is the diagram

If I can figure how to post it

This is the diagram I found.

So what does that mean? The ecm is basically worthless now cause I bypassed it and went carbureted. Ran all my own sensors to factory gauges and got all working except speedometer. Maybe the gray/black isn't the issue? What do you think? I know the switch works on top of the tranny cause there...

I haven't checked that yet... I will be home in about 3 hours and will check then. I wonder if it will if the acuator is opening. I know for sure the acuator is opening. I will check the driveshaft and get back to you... On the diagram I have it looks like the gray/black gets ground and goes to...

I have a schematic but there is a gray/black goes to ecm and I don't know if that has something to do with it.

Ok thanks.

Well I took it to the beach thinking 4lo works but it DOESN'T! So when I wired the actuator all it did was make the actuator open when I put it in 4lo or 4high. But it's only the actuator that's opening I dont think the transfer case is working. Also it is a floor shift not with electronic...

Hmm.... I know that! But the point is it's not factory anymore. I need to trick the transfer case to working. Any other help?

So I swapped the motor in my 97 2door Tahoe to a 4bolt main 350. Removed all wiring and made it carbureted. I decided to change the transmission because had trouble getting the 4l60e to work with out the throttle body and without buying expensive parts. So I rebuilt a th-350 and put that in. So...