Rebound

Dear Sir Good night
I programmed the car to these procedures

TECH 2 PROFESSIONAL use +tis 2000 vetronex
Note
THE SYSTEM OF THIS CAR TXAS TRANSPONDER KEY+IMM0BILIZER +BCM+ECU



GMC YUKON XL 2007
VIN/1GKFC16057J256531
ING 5.3
8 CELENDER

FROM TECH2

SERVICE PROGRAMMING SYSTEM-----------
GMC---------

2007-----------
LD TRK MPV INCOMPETE------------
YUKON XL-----------
CONTINUE
VIN 1GKFC16057J256531
SOFTWAR--------

You store information on your
TECH2

tech2 off
conction tech2 to pc
opin program tis
I chose FROM TIS 2000


FROM TIS 2000


SERVICE PROGRAMMING SYSTEM------------
I chose
TECH2---------
REPROGRAM ECU--------
VEHICLE-------

NEXT
ECM ENGGINE CONTROL MODULE------------

NORMAL------------
NEXT
12614088------
NEXT
1
2
3
4
5
6
7
8
NEXT
Show me the following message

THE HVAC DPM AND OR RCDLR MAY STOP COMMUNICTIONG AND BECOME NONFUNCTIONAL AFTER PROGRAMMING THIS MODULE IF THIS HAPPENS DO NOT REPLACE THE THE HVAC DPM RCDLR MODULE FUNCTIONALITY CAN BE RESTORED BY CYCLING BATREY POWER TO THE HVAC DPM RCDLR MODULE

CRANKSHAFT POSITION VARIATION RELEARN PROCEDURE USING SPECIAL FUNCTION ON TECH2 MAY BE NEEDED AFTER PROGRAMMING
REFER TO SERVICE MANUAL DTC P1336 SYSTEM VARIATION NOT
LEARNED
Then I transfer data from computer to the tech2 successfully
Unplug the machine and then Calculator
I then linked to the car

FROM TECH2


PROGRAM ECU




tech2 reading vin
Makan ensure vin true
At the time of programming the following
incoming message
Programming procedures

PROGRAMMING FAILED---------------



THANKS
[email protected]
[email protected]
iweant help pleas