Pulling Wires through doors

[dye4metal]

alright so i need to run speaker wire from under my rear seat to all the speakers in the doors. im just wondering how hard is it to get to the front and rear? where should i start and is there a good process. also does the pillar between the front and rear doors snap off (the plastic peice inside)?

 

[boostaholic]

Plastic pieces will snap off and you can run the wire through the stock door jamb wire loom. You should not be able to see speaker wires when you open the door.

 

[dye4metal]

Well for the fronts there is no molex and u can easily pop the plastic peices off the front and run the wire through the open connector into the loom. For the rear though there is a molex... should i just drill a hole in where there is empty space? also for the speakers i dont have any "terminals" for them. i soldered wires last time to the connectors. where can i get those terminals?

 

[boostaholic]

Soldering is a better connection but you can use the female insulated connectors available at any home depot or hardware store.

 

[dye4metal]

i think im going to find the connectors since last time i soldered and it took way longer than expected and was a headache. but am i right with how i should go through the rear molex? do i need to go through that molex or are there different places? are there any other suggestions i should know about before i start next week when i get my amp?