Hi Everyone

[BigE]

new member here. been on here for a little while. great site, i already learned some good info here. i recently bought a 2004 Tahoe LT after my 05 Dodge Ram was totaled in an accident. just a few mods done to it. 5% tint all around, 20" wheels wrapped in 285/50/20 toyos, 55w HIDs for lows, 2 Kenwood 12's w/ 1800w Kenwood mono block, fully debadged, removed steps, billet grille. i have some more mods in mind. magnaflow muffler, AEM intake, a 2/4 or 3/5 drop not sure yet, diablo tuner or custom pcm tune, HIDs for fogs and highs, remove the roof rails & XM & OnStar antenna, LED tails smoked or chrome, eventually a rebuilt motor to handle a supercharger (Kenne Bell, Whipple, Magnacharger???), someother stuff also. sorry for the long post and glad to be apart of the forum. thanks. if you have any suggestions on what i should do to it im all ears

 

[BigE]

couple more

 

[JKmotorsports]

Welcome to the forum:beerchug: Clean truck. Just my opinion, but I think dropping it some would clean up the look with less wheel well gap. And if you're thinking about a tune, a custom tune will usually benefit you more than a programmer.

 

[yukondoit]

Welcome. Looks good, good job on the Tahoe.

 

[BigE]

Welcome to the forum:beerchug: Clean truck. Just my opinion, but I think dropping it some would clean up the look with less wheel well gap. And if you're thinking about a tune, a custom tune will usually benefit you more than a programmer.

i will definately drop it, im just not sure which one to go with

 

[BigE]

Welcome. Looks good, good job on the Tahoe.

thanks

 

[M.M. 700]

what brand of rims are those?

Looks good

 

[Yuke2K]

Welcome. Throw a Belltech drop kit on there and you'll have a near perfect, super clean truck.

Looks very good so far though. Give Justin over at Black Bear Performance a call, he'll do you right on a custom tune and you'll never look back. Free re-tunes for life too, so if you ever get into forced induction they'll have your back on the programming and you'll see some mad power.

Welcome aboard! :cheers:

 

[BigE]

what brand of rims are those?

Looks good

Dip Wheels - "X" (D04) 20x8.5

 

[BigE]

Welcome. Throw a Belltech drop kit on there and you'll have a near perfect, super clean truck.

Looks very good so far though. Give Justin over at Black Bear Performance a call, he'll do you right on a custom tune and you'll never look back. Free re-tunes for life too, so if you ever get into forced induction they'll have your back on the programming and you'll see some mad power.

Welcome aboard! :cheers:

from reading on here the majority tends to choose Belltech over any other, now just need to decide whether i want to go 3/5 or 2/4. sure will give BlackBear a call when i have the cash ready to do it.

 

[Yuke2K]

from reading on here the majority tends to choose Belltech over any other, now just need to decide whether i want to go 3/5 or 2/4. sure will give BlackBear a call when i have the cash ready to do it.

Just depends on how low you're looking to go. Personally I prefer lifted with meaty tires, but then again I live in a rather rural part of CO so it's kinda necessary for me. Looking at your pics though, I'd say a 2/4 would be perfect with those wheels. Not too extreme but you'll take just the right amount of space out of the wheel wells and make your shoes fit a bit better.

Just my .02 though.