BlessedHellRide
Full Access Member
How are the tolerance in between doors and panels. A few of my doors dont align to where they are flush with the rear quarter panel. They protrude out a bit. Anyone else have the issue.
Door and Panel Tolerances
- Thread starter BlessedHellRide
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
BlessedHellRide
Full Access Member
bump
jmeyers278
New Member
all my panels line up great...if the front of the door is flush and the rear protrudes some you can adjust the rear door latch in a little
BlessedHellRide
Full Access Member
I check that out, I was told they could adjust it but it would cause wind noise if it did not line up correctly....fml
