Search results

180K+ give or take

https://www.youtube.com/watch?v=Ikaqkr8j7o8&feature=youtu.be What do ya think? I could feel it come up slightly; riding the curvature of the teeth. Going to see if I have warranty on cap and rotor and replace if so. Deff wasnt OEM. Dont see any cross spark.

Crank sensor is new and old one was not damaged. Im going to check to see if the distro might be jumping timing.

No codes and after testing today, I DO have spark during the no start situation. No codes atm. Also, confirmed the noise is from the IAC. If youre up for a long read; http://tahoeyukonforum.com/forum/showthread.php?t=62501

I dont believe it to be fuel related. FP has same results in either running or not running condition. Wouldnt bad cap cause it to run rough, not a no run and run perfectly scenario?

GF's 99 Yukon has been developing a no start issue. Motor comes to an abrupt halt, shudder and shunts when cranking. Sometimes complete stops then continues cranking. Took off cap and rotor, both were dirty; cleaned points with a Dremel wire wheel. Fired right up multiple times, told girl...

I wish I had seen this post before I ran though all my fuses. And the started is covered in oil. I followed the line from the starter to the wire loom that's at the back of the block. Opened the entire fuse panel (even the back). Took (broke) off the plastic around the column, and inspected...

I pulled the plastic cover off of the steering column and traced the lines I could see. Looked very closely at any point that rubs when the steering column is tilted; all looked good. According to Haynes, the line I should be looking for goes to the fuse and to the starter relay. Am I right...

Need help tracking down a short as IGN-A fuse keeps popping the second I turn the ignition to crank. My Chiltons manual says its good for model years up to 98 (says the same for the engine schematic). Can someone with a Haynes or another manual check me? Im showing positive cable (red) to...

Dont know where you shop, or where you work. But I think that $70 for $.10 worth of plastic. Do you have a link explaining this MPFI? I had already done a Seafoam. Didnt really do much as I found out what was wrong. Inspected the plug in cyl #4 and noticed a very small crack on what I believe...

Been reading up on this Spider Injection; strangest crap Ive ever seen in a vehicle. Why in the world would anyone want to put this thing on here under the plenum no less? Going to try out this expensive cap and rotor and see what happens.

Just bought a 1999 Yukon 5.7 with with a few issues. Runs fairly well, when cruising on the highway it runs great. At idle cold or hot, I can feel a bit of a miss. Before getting the truck home I stopped at Advance to check the codes: B0225 B0227 B0235 B0226 All the B codes had to do...