Search results

Hi all, 96 Tahoe- I need to remove the 4 roof strips, as I am going to paint the truck soon. I want to make sure that the rust (failed GM paint issue) did not get under the strips. I don't know if they simply pop off, or have a stud on the underside and have to remove the headliner to get to...

Hi Snow, Thanks for the reply. No, I don't think it's the coolant sensor. In the first post, the engine would idle fine after warmup. Shut the engine off for 2 minutes, restart, and upon starting, the RPM would go up to 1800 rpm. Not normal. After it warmed up, idle was perfect. The...

Hi, Just recently my '96 started having an issue with high RPMs on startup. First start of the day, it would rev to maybe 1200 right after start, then taper off to around 800 which I think would be normal. Drive for a few miles, fully warmed up. Upon starting again, the RPM would go to at...

Hi, Generally, you can test the fuel pressure at the fuel rail, there is a Schrader valve (same method of valve as your tire stems), connect the pressure gauge there. The regulator can be at fault also, the fuel pump itself. Have you changed your fuel filter? Rather than to paraphrase the...

Never offered as a factory option from GM. Obviously one of the conversion companies did it. Such as: http://www.uswd.com/american.htm

"Check engine light comes on, I check with my OBD2 and get bank 2 O2 sensor. OK I got it, I need to change them, and preferrably all 4 at the same time." Remember, just because you have an O2 code doesn't mean the sensor is bad. (Or for any other sensor you get a code for) You should check...

Hi, I have had to find a good frame shop years ago, and found Mike's Frame shop in Canoga park the best. This is a genuine frame shop with all the racks, 4 post pullers, etc. He's been in business since about 1977. I went there in 1983 and he straightened out my Mercury Capri fromt end, no one...

Just passed 152.2K. Nothing major, replaced intake gasket (due to the Deathcool), 4WD axle and rear axle seals. Engine still runs quiet.

Hello all, Great forum you have here, and I have been reading many of the posts. I have searched for the answer already, but have only seen info on how to remove the bezel, (around the radio/inst cluster), or dash removal for newer years. What I want to do , is to finally get behind...