Go Back   Tahoe Forum - Chevy Tahoe Forum > Search Forums

Register to remove these ads.


Showing results 1 to 25 of 186
Search took 0.02 seconds.
Search: Posts Made By: Ice98
Forum: General Tahoe/Yukon Discussion Forum 04-04-2016, 01:42 AM
Replies: 2
Views: 1,832
Posted By Ice98
Could be shift linkages or possibly your shift...

Could be shift linkages or possibly your shift solenoids, but transmissions are beyond me
Forum: General Tahoe/Yukon Discussion Forum 04-02-2016, 12:32 AM
Replies: 4
Views: 2,042
Posted By Ice98
They wont hit the tail lights anyways, the hinges...

They wont hit the tail lights anyways, the hinges stop the swing...they are designed for that hold to be released in order to open them more fully


go to a local junk yard and just pull one off...
Forum: Technical Discussions 03-31-2016, 07:05 AM
Replies: 5
Views: 2,013
Posted By Ice98
I cant say for sure either way, but in my...

I cant say for sure either way, but in my suburban the tank is installed very far back, I am not sure the Tahoe has enough front-to-back clearance for the tank....also, it is a 42 gallon tank
Forum: General Tahoe/Yukon Discussion Forum 03-20-2016, 11:52 PM
Replies: 6
Views: 2,581
Posted By Ice98
You can get a set of helper springs from Hellwig...

You can get a set of helper springs from Hellwig that bolt on over the stock springs, it helps a lot with the rear sag and adds additional carrying capacity
Forum: Technical write ups & Installation Guides 03-10-2016, 01:32 AM
Replies: 13
Views: 10,427
Posted By Ice98
Hellwig helper springs, add an additional 2,000...

Hellwig helper springs, add an additional 2,000 pounds of weight capacity to the spring pack (or so they claim) and bolt right over the stock, really helps the saggy spring issue on these heavy...
Forum: Technical write ups & Installation Guides 03-10-2016, 01:27 AM
Replies: 13
Views: 10,427
Posted By Ice98
LED Light replacements, including under the hood,...

LED Light replacements, including under the hood, dome lights, map/reading lamps, door safety lights, and floor lights
...
Forum: Technical write ups & Installation Guides 03-10-2016, 01:19 AM
Replies: 13
Views: 10,427
Posted By Ice98
Here is where the current 1000w hifonix amp is...

Here is where the current 1000w hifonix amp is installed under the passenger seat. This will be replaced with a 2/0 wire run to the aux battery and a 3000w pyle elite series and will eventually be...
Forum: Technical write ups & Installation Guides 03-10-2016, 01:16 AM
Replies: 13
Views: 10,427
Posted By Ice98
Pics of the second battery installation, I...

Pics of the second battery installation, I neglected to take pics of the tray as I mocked it up, I couldn't find any of the stock trays for sale and the out of stock items were priced at almost 3x...
Forum: General Tahoe/Yukon Discussion Forum 03-07-2016, 07:08 PM
Replies: 25
Views: 10,276
Posted By Ice98
It not be hard to run a wire from your turn...

It not be hard to run a wire from your turn signal wires to the mirror spot either way
Forum: Technical write ups & Installation Guides 03-04-2016, 12:06 AM
Replies: 13
Views: 10,427
Posted By Ice98
Got the battery tray mocked up and installed ...

Got the battery tray mocked up and installed

Installed the 140w amp

Installed the big3 upgrade to the stock battery

Installed second battery with isolator and cables/grounds

Seems to be...
Forum: Technical write ups & Installation Guides 02-23-2016, 03:20 AM
Replies: 13
Views: 10,427
Posted By Ice98
Got the parts for the battery tray today, going...

Got the parts for the battery tray today, going to be something of a custom setup.... Also got most of the lugs put on cables and everything crimped, have the new wire harness for the alt and just...
Forum: Technical write ups & Installation Guides 02-17-2016, 12:38 AM
Replies: 13
Views: 10,427
Posted By Ice98
So that the only thing the 2nd battery does is...

So that the only thing the 2nd battery does is operates the starter, everything else (lights, stereo, amp, inverter, 12v sockets, etc) would run off the other battery

Alternatively I could just...
Forum: Technical write ups & Installation Guides 02-16-2016, 12:39 AM
Replies: 13
Views: 10,427
Posted By Ice98
I want to be able to turn the power off to one...

I want to be able to turn the power off to one when using the other, the amount of power each draws is far too much for the alternator alone so running both would drain the batteries too quickly

...
Forum: Technical write ups & Installation Guides 02-15-2016, 01:54 AM
Replies: 13
Views: 10,427
Posted By Ice98
Swapped out (most of) my T10 lights with LED...

Swapped out (most of) my T10 lights with LED bulbs, also did the dome lights

the Domes are super bright now, the door safety lights and personal reading laps are replaced (except the rearmost) and...
Forum: General Tahoe/Yukon Discussion Forum 02-14-2016, 07:01 AM
Replies: 19
Views: 5,743
Posted By Ice98
Why not just take a module from an older vehicle...

Why not just take a module from an older vehicle and cut and paste? Even if the module is a different model, the wiring should be the same or very similar, and the programming needed for new keys is...
Forum: Technical write ups & Installation Guides 02-14-2016, 06:59 AM
Replies: 13
Views: 10,427
Posted By Ice98
Adding second battery /w Isolator and amp power

So I have many parts on order, and on the order of events is the following

1. Big 3 upgrade, much larger cables for the alternator, battery +, and ground cables
2. Upgrade from 105a to 140a...
Forum: General Tahoe/Yukon Discussion Forum 02-11-2016, 07:06 PM
Replies: 1
Views: 2,051
Posted By Ice98
Easiest and cheapest thing to start with is to...

Easiest and cheapest thing to start with is to double check all your electrical connections, add dialectric grease, then move on to the next thing. Make sure all your plug wires are tight, the plugs...
Forum: General Tahoe/Yukon Discussion Forum 02-07-2016, 12:13 AM
Replies: 3
Views: 2,550
Posted By Ice98
Mine turned out to be a spindle bearing that went...

Mine turned out to be a spindle bearing that went bad, you have to pop the rear diff cover off to check it but my mechanic showed me a picture and the diff magnet in the back looked like a damn...
Forum: General Tahoe/Yukon Discussion Forum 02-07-2016, 12:08 AM
Replies: 6
Views: 2,239
Posted By Ice98
Still on side posts? Get a few marine...

Still on side posts?

Get a few marine terminals (Assuming your battery also has top posts), screw your stock cables to those and then transfer it to the top posts

I tell you, SINGLE BEST THING...
Forum: Technical Discussions 02-06-2016, 11:59 PM
Replies: 2
Views: 2,262
Posted By Ice98
Anyone done a dual battery upgrade?

Looking to purchase the cables and battery to add a second battery

Planning on running an amp off the second battery and linking both with an isolator between so that the starter battery cannot be...
Forum: Technical Discussions 02-06-2016, 11:54 PM
Replies: 5
Views: 1,926
Posted By Ice98
Is it a 4l60 or 4l60-e? This gives some...

Is it a 4l60 or 4l60-e?

This gives some good info
http://www.automotiveforums.com/t919845-difference_between_4l60_and_4l60e.html
Forum: Technical Discussions 02-06-2016, 11:51 PM
Replies: 23
Views: 5,270
Posted By Ice98
I did it with just a wrench, at least to replace...

I did it with just a wrench, at least to replace the fuel filter, it may depend on where you are disconnecting it as I have never done it elseware
Forum: Technical Discussions 02-06-2016, 11:46 PM
Replies: 4
Views: 2,251
Posted By Ice98
I ended up going to O'Reilly's where the...

I ended up going to O'Reilly's where the associate cut off a bit of tube so we could take it outside and match it up, ended up buying a couple feet and it cost me.....$0.63!

Which was good,...
Forum: Technical Discussions 02-06-2016, 11:44 PM
Replies: 7
Views: 2,519
Posted By Ice98
Mine didn't have that, of course the entire rear...

Mine didn't have that, of course the entire rear axle was replaced not long ago and it may have come off another suburban, Tahoe, Silverado, who knows
Forum: Technical Discussions 01-16-2016, 01:22 AM
Replies: 4
Views: 2,051
Posted By Ice98
Pretty much, but you can simplify the connections...

Pretty much, but you can simplify the connections by soldering/heatshrinking the 4pin round into the 7-pin socket


Would cost you about $150 to buy and install a brake controller, but will be far...
Showing results 1 to 25 of 186

 
Forum Jump



 
Advertisement

Other Sponsors






All times are GMT -4. The time now is 09:38 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
All rights reserved and copyrighted
Fully Driven Auto Network
GM Truck Forum
Ford Raptor Forum
Dodge Ram Forum
Chevy Cobalt Forum
Chevy Camaro Forum
FJ Cruiser Forum
Ford Truck Forum
88-98 GM Truck Forum
73-87 Gm Truck Forum
Ford Expedition Forum
Chevy Equinox Forum
Chevy Cruze Forum
Jeep Liberty Forum
Jeep Forum
Dodge Ram SRT10 Forum
Chrysler 200 Forum
Scion xD Forum
Scion xB Forum
Dodge Challenger Forum
SRT Forum
Nissan Titan Forum
Buick Enclave Forum
Cadillac Forum
Cadillac XTS Forum
TRD Forum
Central US Mopars
Southeast Mopars
Cadillac CTS Forum
Oklahoma Dodge Ram Club
Softball Forum